Invacare Spree XT, Owner'S Operator And Maintenance Manual

Page: 36 / 76

SECTION 4—FRONT RIGGINGS
Spree XT
36
Part No 1118364
4. Reinstall the socket bolt through the
mounting holes of the footplate and
footrest support.
WARNING
DO NOT overtighten socket bolt and
locknut. Footrest MUST be able to
rotate upward from the horizontal to
the vertical position.
5. Secure the footplate to the footrest
support with the coved washer and
locknut.
FIGURE 4.4 Installing/Removing Swingaway
Footrest - 70° MFX, 90°, 70° LIFT and 90°
LIFT Footrests
Installing Adjustable Angle Flip-Up Footplate Hinge
NOTE: For this procedure, refer to FIGURE 4.5.
1. Position the adjustable angle flip ‐ up footplate hinge on the footrest support tube at the
desired height.
2. Position the hardware on the footrest support as shown in FIGURE 4.4.
3. Flip the footplate hinge to the up position.
NOTE: The footplate hinge will fall to the down position.
4. Tighten the socket screw and locknut
that secure the footplate hinge to the
footrest support until the footplate
hinge remains in the up position.
5. Check the up and down motion of the
footplate hinge to make sure the user of
the wheelchair can operate the
footplates easily.
NOTE: If the footplate ʹ s motion is too tight,
loosen the socket screw and locknut
approximately ¼ ‐ turn.
NOTE: If the footplate ʹ s motion is too loose,
tighten the socket screw and locknut
approximately ¼ ‐ turn.
FIGURE 4.5 Installing Adjustable Angle
Flip-Up Footplate Hinge
Height
Adjustment
Holes
Socket Bolt
Locknut
Footrest Support
Footplate
Footrest
Support
Tube
Socket Screw
Locknut
Footplate
Hinge