intrepid Intrepid 6140 Director, Installation And Service Manual

Page: 247 / 430

5
RRP: Port Module Card (UPM and XPM)
5-11
Removal and Replacement Procedures (RRPs)
RRP: Port Module Card (UPM and XPM)
Use the following procedures to remove or replace a UPM or XPM
card. A list of tools required is provided.
Tools Required The following tools are required to perform these procedures.
• Door key with 5/16-inch socket (provided with the FC-512
Fabricenter equipment cabinet).
• ESD grounding cable and wrist strap.
• Torque tool and hex adapter (provided with the director).
• Fiber-optic protective plugs (provided with the director).
• Protective caps (provided with fiber-optic jumper cables).
• Fiber-optic cleaning kit.
Removal To remove a UPM or XPM card:
1. Notify the customer that all ports on the defective port card will
be blocked. Ensure the customer system administrator quiesces
Fibre Channel frame traffic through any operational ports on the
card and sets attached devices offline.
2. If the director is installed in a stand-alone configuration, go to
step 4 . If the director is rack-mounted, perform one of the
following:
— If the director is installed in a McDATA-supplied FC-512
Fabricenter equipment cabinet, insert the 5/16" door tool into
the socket hole at the right top of the rear door. Turn the tool
counter-clockwise to unlock and open the door.
— If the director is installed in a customer-supplied equipment
cabinet, unlock and open the cabinet rear door as directed by
the customer representative.
3. To remove a rear-mounted FRU, remove the RFI shield.
ATTENTION! To avoid causing machine errors or damage while working on
the director, follow ESD procedures by connecting a grounding cable to the
director chassis and wearing an ESD wrist strap.
4. Follow ESD procedures by attaching a wrist strap to the director
chassis and your wrist ( Figure 5-1 ).