intrepid Intrepid 6140 Director, Installation And Service Manual

Page: 165 / 430

Maintenance Analysis Procedures
3-45
Maintenence Analysis Procedures
21
A port card failed and the card must be replaced ( RRP: Port Module
Card (UPM and XPM) on page 5-11).
• This procedure is concurrent and can be performed while
director power is on.
• Verify the location of the failed card. Figure 3-2 and Figure 3-3
show UPM card numbers (0 through 34), port numbers (00
through 139), and bolded logical port addresses.
• Notify the customer that all ports on the defective card are to be
blocked. Ensure the customer system administrator quiesces
Fibre Channel frame traffic through any operational ports on the
card and sets attached devices offline.
• Perform an external loopback test for all ports on the
replacement card as part of FRU removal and replacement
(
Performing Loopback Tests on page 4-21).
• Perform the data collection procedure as part of FRU removal
and replacement (
Collecting Maintenance Data on page 4-32).
Did port card replacement solve the problem?
NO YES
↓
The director appears operational. Exit MAP.
Contact the next level of support. Exit MAP.
22
A message appeared in the
Link Incident Log
or an event code 581,
582, 583, 584, 585, or 586 was observed at the console of an OSI
server attached to the product reporting the problem. Clear the link
incident (Element Manager only).
a. At the Hardware View , right-click the port. A pop-up menu
appears.
b. Select
Clear Link Incident Alert(s)
. The
Clear Link Incident
Alert(s) dialog box displays.
c. Select the
This port (n) only
radio button and click
OK
. The link
incident clears.
d. Monitor port operation for approximately five minutes.
Did the link incident recur?
YES NO