Intermec Trakker Antares 2420, User Manual

Page: 56 / 480

TRAKKER Antares 2420 and 2425 Hand-Held Terminal User’s Manual nuggetf
code39
1-32
Step 2: Using the Application (continued)
VT/ANSI TE Login Screen
<login:
242XU.163
*
a. Configure the terminal emulation application (if necessary). For
help, see the TRAKKER Antares Terminal Emulation User’s
Guide.
b. Log in to a terminal emulation session.
c. Start using the T2425 to collect and transmit data.
Turning the Terminal On and Off
The terminal’s Suspend/Resume key is the
L key in the upper left corner of the keypad,
as shown in this illustration.
When you press
L to turn off the
terminal, the terminal does not actually
shut off, but goes into a Suspend mode.
This mode is referred to as “off” in the
rest of this manual. In Suspend mode,
the terminal continues to power all
memory and turns off the power to most
of the hardware.
When you press
L to turn on the
terminal, the terminal either resumes
exactly where it was when you turned it
off, or the terminal boots and restarts
your application. Resume is controlled
through a parameter or command called Resume Execution. By default, the terminal
restarts your application. For help, see “Resume Execution” in Chapter 9.
If you change the main battery pack while the terminal is turned off, the terminal resumes
or boots the next time the terminal is turned on. The backup battery saves all memory
while you change the main battery pack.
I/O
Enter Enter
F6
F1
F7
F2
F8
F9
F4
F10
F3
F5
Suspend/
Resume key
242XU.045