Intermec Trakker Antares 2420, User Manual

Page: 309 / 480

Co de 39
Nugget Configuration Command Reference
9-41
9
*8* *9*
*8* *9*
3. Scan this bar code:
Exit Accumulate Mode
*-/*
*-/*
Controller Connect Check Send Timer
Purpose: During periods of inactivity on the T2425, the terminal still sends messages to the
DCS 300 to check the RF connection. The terminal sends a message at the time interval
set for the Controller Connect Check Send Timer. The timer countdown resets each time
a valid message is sent or received.
Power Management Tip: Intermec strongly recommends that you use the optimum
setting of 35 seconds to preserve the main battery pack’s power.
Syntax:
NQdata
Acceptable values for data are any number from 1 to 3600 seconds (60 minutes).
Default: 35 seconds
Scan: To set the default controller connect check send timer, scan this bar code:
Default Controller Connect Check Send Timer
*$+NQ35*
*$+NQ35*
Or: To set the controller connect check send timer:
1. Scan this bar code:
Enter Accumulate Mode / Set Controller Connect Check Send Timer
*+/$+NQ*
*+/$+NQ*