Intermate100 and Intermate101 Print Server Administration Manual
167
Services in “Input Control”: ThinPrint
c
“Bandwidth (bit/sec.)”.
The Intermate1xx can perform “client-side”
reduction of bandwidth so that even less
bandwidth is used than specified by the
Thin-
server. Default is 0 (=disabled).
Check with your network administration for a
suggested value if you want to enable this
feature.
d
“Output to”. Choose where you want the output
of ThinPrint jobs directed. This is the same
process as described in
“Common Feature:
How to Direct Output” [page 159]
, with the
following modifications:
If you are using a G22-based print server, there
will be nine valid choices: Logical Printer 0 to
and including Logical Printer 8.
You will not be able to direct ThinPrint to a
network destination, even if you have
purchased an NDO key.
If you are using a G32-based print server, you
will have the nine choices using the logical
printer layer (as described for G22)—plus five
direct choices: Local, Network Destination 1,
Network Destination 2, Network Destination 3,
Network Destination 4.
With all products, it is possible to direct print
jobs from the host application through the
Intermate1xx to the destination of your choice,
regardless of the setting in “Output to”; see
below.
e
Remember to “Save & Cont.” and then
“Reboot” to activate.
Directing output from the host application
(code level 2252 and higher)
When you identify the target with an IP address, it is possible
Summary of Contents for Intermate 100
