Intel SRCMR, User Manual

Page: 70 / 180

70 Intel RAID Controller SRCMR User’s Guide
Installing the Intel RAID Controller SRCMR as an
Additional Controller
Two cases are discussed below.
No Intel RAID Controller SRCMR Has Yet Been Configured for
UnixWare
In this case, the Intel RAID Controller SRCMR driver must be installed from the UnixWare
BTLD-Disk by means of the UnixWare desktop and the options “System Setup”, “Application
Setup”. Alternatively, this procedure can be carried out from the UnixWare shell: “pkgadd -d /dev/
dsk/f0t” (Intel RAID Controller SRCMR driver disk in drive 0).
An Intel RAID Controller SRCMR Has Already Been Configured
for UnixWare
In this case, you only have to add an additional entry for the new Intel RAID Controller SRCMR.
This is carried out by the command.
/etc/scsi/pdiadd -d DRQ -v IRQ -m MEM srch
For DRQ use 0 (not necessary for PCI boards). For IRQ write the IRQ number that Intel RAID
Controller SRCMR uses. MEM corresponds to the DPMEM address of the Intel RAID Controller
SRCMR (which is displayed in the BIOS message of the Intel RAID Controller SRCMR after
power up). In both cases, you have to carry out a cold boot to use the new Intel RAID Controller
SRCMR under UnixWare.
Example: /etc/scsi/pdiadd -d 0 -v 12 -m c8000 srch.
Then reboot of the UnixWare system. No kernel link is required because the driver will be
dynamically loaded.