Intel ISP4400 - Server Platform - 0 MB RAM, Product Manual

Page: 61 / 114

Removing and Installing System Components 61
Installing a Power Subsystem Bay
WARNINGS
System power on/off: The on/off button on the front panel DOES NOT
turn off the system AC power. To remove power from system, unplug
the AC power cords from the wall outlet or the system.
Hazardous conditions, power supply: Hazardous voltage, current, and
energy levels are present inside the power supply. There are no
user-serviceable parts inside it; servicing should be done by technically
qualified personnel.
1. Observe the safety and ESD precautions at the beginning of this chapter.
2. Remove the SKA4 baseboard. See "Removing the Baseboard" on page 53.
3. Release four screws. There are two on each side of the chassis. One of the two screws is
noted by "A" in Figure 27 on page 58.
4. Lift the piece of sheet metal that typically covers the top of the power subsystem bay.
5. Place the power subsystem bay in the front of the chassis. As you face the front of the server,
the power subsystem bay is placed on the far left side. The front of the power subsystem bay
should be flush with the front of the system.
6. Tighten the screw on the front of the power subsystem bay. This is noted by "F" in Figure 27
on page 58.
7. Route the AC distribution cable into the chassis retention feature.
8. Attach the DC power cables to the hard drive bay and to any peripheral bay devices.
9. Install the SKA4 baseboard. See "Installing the Baseboard" on page 55.
10. Place the piece of sheet metal that covers the top of the power subsystem bay so that the front
of the sheet metal is flush with the front of the system. The metal plate is noted by "A" in
Figure 29.
OM09955
A
Figure 29. Metal Plate Covering the Power Subsystem Bay
11. Tighten the screws on each side of the chassis. One of the two screws for each side is noted by
"A" in Figure 27 on page 58.