Intel ISP4400 - Server Platform - 0 MB RAM, Product Manual

Page: 14 / 114

14 SRKA4/ISP4400 Server System Product Guide
Table 2. Chassis Feature Summary (continued)
Feature Description
D. Cooling Installed:
Fan board assembly and six fans in a redundant (5+1) fan array or three fans in a
non-redundant (3+0) fan array. The fans cool the baseboard and other
components.
In a 5+1 configuration, a failed fan may be removed and installed without shutting
down the server. This process is called hot-swapping. Hot-swapping fans can
only be performed by a qualified service technician.
E. Electronics Bay
(E-Bay) The E-Bay contains the Intel

SKA4 baseboard. The baseboard has the following
major components:
•
Up to four Intel

Pentium

III Xeon

processors
•
Server Set III HE chipset
•
Up to sixteen PC/100-compliant Registered ECC SDRAM memory modules that
support up to 16 gigabytes of Error Checking and Correcting (ECC)
Synchronous Dynamic RAM
•
32-bit, 33 MHz, 5V PCI slots and three embedded devices
•
64-bit, 66/33 MHz, 3.3V hot-plug PCI slots and one embedded device
•
64-bit, 33 MHz, 5V hot-plug PCI slots and three embedded devices
•
ISA bus segment with three embedded devices
•
Two externally accessible USB port and one internally accessible USB header
•
One IDE connector, supporting up to two ATA33 compatible devices
With the exception of the hot-plug PCI cards, the E-Bay can only be accessed by
qualified service technicians.
E1. E-Bay
(Overhead View)
An overhead view of the E-Bay.
E2. Hot-plug PCI Slots Six hot-plug PCI slots located within the E-Bay.
WARNING
The total power requirement for the SRKA4 MP Server System exceeds
the 240 VA energy hazard limit that defines an operator-accessible area.
Only qualified service technicians should access the processor, memory,
power subsystem, and non hot-plug/hot-swap areas of the SKA4
baseboard.
Peripherals
Peripheral Bay
The chassis contains one peripheral bay for CD-ROM, DAT, and floppy drives. The peripheral
bay contains two smaller bays: a device bay and a configurable media bay.
Device Bay
The device bay accommodates either a 5.25-inch CD-ROM or a DAT drive. Only qualified
service technicians should remove and install components in the device media bay.