Intel ISP4400 - Server Platform - 0 MB RAM, Product Manual

Page: 54 / 114

54 SRKA4/ISP4400 Server System Product Guide
13. Remove the power supply AC bracket.
a.
Release the screw securing the connector. The screw is noted by "A".
b. Slide the bracket up and towards the inside of the chassis.
c. Drape the AC bracket over the left side of the E-Bay assembly.
OM09950
A
B
Figure 24. Power Supply AC Bracket
A. Screw securing the connector
B. Power supply inlet connector
14. Remove the Voltage Regulator Modules (VRM). See the SKA4 Baseboard Product Guide for
instructions.
15. Remove the processors and any termination processors. See the SKA4 Baseboard Product
Guide for instructions.
16. Remove the processor retention guides. See the SKA4 Baseboard Product Guide for
instructions.
17. Remove any hot-plug PCI add-in boards. See "Removing a Hot-plug PCI Add-in Board" on
page 30.
18. Remove the plastic slot dividers. First, pull up on the end at the front of the E-Bay, and then
slide the other end out of the back panel at the back of the E-Bay.
19. Remove the screws securing the baseboard to the chassis. There should be two of them.