Intel ISP4400 - Server Platform - 0 MB RAM, Product Manual

Page: 39 / 114

A Detailed Description of Chassis Features 39
WARNING
The total power requirement for the SRKA4 MP Server System exceeds
the 240 VA energy hazard limit that defines an operator-accessible area.
Only qualified service technicians should access the processor, memory,
power subsystem, and non hot-plug areas of the SKA4 baseboard.
Peripherals
Peripheral Bay
The chassis contains one peripheral bay for CD-ROM, DAT, and floppy drives. The peripheral
bay contains two smaller bays: a device bay and a configurable media bay.
Device Bay
The device bay accommodates either a 5.25-inch CD-ROM or a DAT drive. Intel strongly
recommends NOT installing any device, such as a hard drive, requiring airflow cooling in the
device bay. Installing such a device in this bay causes environmental conditions to exceed the
cooling and electromagnetic interference (EMI) constraints of the system.
Configurable Media Bay
The configurable media bay supports either one of the following configurations:
•
A .5-inch slim line floppy drive and .5-inch slim line CD-ROM drive
•
A 3.5-inch floppy drive
Hard Drives
The chassis contains up to one hard drive bay. The hard drive bay supports either one of the
following configurations:
•
Five 3.5-inch by 1.0-inch hot-swap Adaptec Ultra 160/m SCSI SCA hard drives
•
Three 3.5-inch by 1.6-inch hot-swap Adaptec Ultra 160/m SCSI SCA hard drives
Opening the front bezel door provides user access to the hard drives. As part of the hot-swap
implementation, each hard drive requires a hard drive carrier. When you remove a hard drive from
the system, you remove both the carrier and the hard drive. The drive is attached to the carrier by
four screws. The carrier is locked into the hard drive bay by a locking handle.