Intel ISP4400 - Server Platform - 0 MB RAM, Product Manual

Page: 49 / 114

49
6 Removing and Installing System Components
Tools and Supplies Needed
•
Phillips screwdriver (#1 and #2)
•
Flat head screwdriver (#2)
•
Jumper-removal tool or needle-nosed pliers
•
Antistatic wrist strap and conductive foam pad (recommended)
•
Pen or pencil
•
Equipment log: As new parts are integrated into the system, add information about them to the
equipment log (page 91). Record the model and serial number of the system, all installed
options, and any other pertinent information specific to the system. Some of this information
may be required when running the SSU.
Safety: Before You Remove the Front and Top Covers
These warnings and cautions apply whenever you remove the top and front covers of the system.
Only a technically qualified person should integrate and configure the system.
WARNINGS
Hazardous conditions, power subsystem: Hazardous voltage, current,
and energy levels are present inside the power subsystem. There are no
user-serviceable parts inside it; servicing should be done by technically
qualified personnel.
The total power requirement for the SRKA4 MP Server System exceeds
the 240 VA energy hazard limit that defines an operator-accessible area.
Only qualified service technicians should access the processor, memory,
power subsystem, and non hot-plug areas of the SKA4 baseboard.
CAUTIONS
Electrostatic discharge (ESD) and ESD protection: ESD can damage
disk drives, boards, and other parts. Intel recommends that all procedures in
this chapter are performed only at an ESD-protected workstation. If one is
not available, provide some ESD protection by wearing an antistatic wrist
strap attached to chassis ground

any unpainted metal surface

on your
system when handling parts.