Intel ISP4400 - Server Platform - 0 MB RAM, Product Manual

Page: 15 / 114

Chassis Description 15
Configurable Media Bay
The configurable media bay supports either one of the following configurations:
•
A .5-inch slim line floppy drive and ½-inch slim line CD-ROM drive
•
A 3.5-inch floppy drive
Only qualified service technicians should remove and install components in the configurable
media bay.
Hard Drives
The chassis contains up to one hard drive bay. The hard drive bay supports either one of the
following configurations:
•
Five 3.5-inch by 1.0-inch hot-swap Adaptec Ultra 160/m SCSI SCA hard drives
•
Three 3.5-inch by 1.6-inch hot-swap Adaptec Ultra 160/m SCSI SCA hard drives
Opening the front bezel door provides user access to the hard drives. As part of the hot-swap
implementation, each hard drive requires a hard drive carrier. When you remove a hard drive from
the system, you remove both the carrier and the hard drive. The drive is attached to the carrier by
four screws. The carrier is locked into the hard drive bay by a locking handle. Figure 4 shows the
orientation of the drive in the carrier. The carrier is upside down in this figure.
OM09937
E A B C D
Figure 4. Hard Drive Secured in Drive Carrier
A. Hard drive carrier
B. Two of four fasteners used to attach drive to carrier
C. Hard drive
D. Connector
E. Locking handle
Each hard drive is connected to an Adaptec Ultra/m 160 SCSI hot-swap backplane. The backplane
provides industry-standard 80-pin SCA-2 connectors for each hard drive and accepts 10k or slower
drives that consume up to 23 watts of power. If another type or slower Ultra 160 SCSI SCA drive
is installed, make sure that the drive meets these backplane and carrier requirements.