Intel ISP4400 - Server Platform - 0 MB RAM, Product Manual, Page: 56 / 114

56 SRKA4/ISP4400 Server System Product Guide
5. Using needlenose pliers, install the plastic rear retention mechanism located at the front of the
E-Bay. The Rear Retention Mechanism is noted by "A" in Figure 26.
OM09952
A
Figure 26. Rear Retention Mechanism
6. Place the rug at the bottom of the E-Bay.
7. Slide the E-Bay into the chassis. As you slide the E-Bay in, make sure that the power cord
does not become wedged between the two parts of the chassis.
8. Attach the four screws on the top and bottom edges of the rear subchassis. See Figure 25 on
page 55.
9. Attach the screws securing the baseboard to the chassis. There should be two of them.
10. Install the plastic slot divider. First, slide one end into the back panel, and then press the other
end into the chassis.
11. Install any hot-plug PCI add-in boards. See "Installing a Hot-plug PCI Add-in Board" on
page 31.
12. Install the processor retention guides. See the SKA4 Baseboard Product Guide for
instructions.
13. Install the processors and any termination processors. See the SKA4 Baseboard Product Guide
for instructions.
14. Install the Voltage Regulator Modules (VRM). See the SKA4 Baseboard Product Guide for
instructions.
15. Install the power supply AC bracket. See Figure 24 on page 54.
a.
Slide the bracket through the back panel from inside the chassis.
b. Once in place, slide the bracket up into the slot.
c. Attach the screw securing the bracket.
16. Add any 33 MHz half-length PCI add-in boards. See the SKA4 Baseboard Product Guide for
instructions.
17. Connect internal cables to the baseboard. Cables and connectors include
•
Three ribbon cables at the front of the E-Bay
•
Three power connectors
•
A ribbon cable located next to the non-hot-plug PCI add-in boards at the back of the E-Bay
•
A 13-pin AUX-IMB connector