Intel D815EEA2, Product Manual

Page: 94 / 96

Intel Desktop Boards D815EEA2, D815EPEA2, D815EFV, and D815EPFV Product Guide
94
Chassis and Component Certifications
Ensure that the chassis and certain components; such as the power supply, peripheral drives,
wiring, and cables; are components certified for the country or market where used. Agency
certification marks on the product are proof of certification. Typical product certifications include:
In Europe
The CE marking signifies compliance with all applicable European requirements. If the chassis
and other components are not properly CE marked, a supplier’s Declaration of Conformity
statement to the European EMC directive and Low Voltage directive (as applicable), should be
obtained. Additionally, other directives, such as the Radio and Telecommunications Terminal
Equipment (R&TTE) directive may also apply depending on product features.
In the United States
A certification mark by a Nationally Recognized Testing Laboratory (NRTL) such as UL, CSA, or
ETL signifies compliance with safety requirements. Wiring and cables must also be UL listed or
recognized and suitable for the intended use. The FCC Class B logo for home or office use
signifies compliance with electromagnetic interference (EMI) requirements.
In Canada
A nationally recognized certification mark such as CSA or cUL signifies compliance with safety
requirements. The Industry Canada statement at the front of this product guide demonstrates
compliance with Canadian EMC regulations. Industry Canada recognizes and accepts FCC
certification as denoting compliance with national electromagnetic interference (emissions)
requirements.
Prevent Power Supply Overload
Do not overload the power supply output. To avoid overloading the power supply, make sure that
the calculated total current loads of all the modules within the computer is less than the output
current rating of each of the power supplies output circuits.
Place Battery Marking
There is insufficient space on this desktop board to provide instructions for replacing and
disposing of the Lithium ion coin cell battery. For system safety certification, the following
statement or equivalent statement is required to be permanently and legibly marked on the chassis
near the battery.
CAUTION
Risk of explosion if battery is incorrectly replaced.
Replace with only the same or equivalent type recommended by the manufacturer. Dispose of used
batteries according to the manufacturer’s instructions.