INOVA AUTOMATION
NICE Series Integrated Elevator Solution
–
N Quick Start-Up Guide V1.0
2
1. Safety Information and Precautions
DANGER WARNING CAUTION
N Integrated Elevator controller should only be installed, commissioned and maintained by qualified
and competent personnel
Before power is applied to the controller, ensure all covers are fitted to the controller and is fitted in a suitable
enclosure
Dangerous high voltages are present when the input power supply is connected to the controller
Before attempting any work on the controller or motor or power connected other elevator equipment, isolate and
lock off the input power supply
After disconnecting the supply, wait at least 10 minutes to let the controller
’
s internal capacitors discharge
completely before removing the cover. Prove dead using a voltage tester
Wiring must be performed only by qualified personnel under instructions described in suitable electrical wiring
diagram and user manual
Ensure that the cabling satisfies the EMC requirements and local codes. Use wire sizes recommended in the
manual
Use the shielded cable for the encoder, and ensure that the shield is reliably grounded at one end
Do not touch the rotating part of the motor during the motor auto-tuning or running
Do not start/stop the controller by turning on or off the contactor
When mounting the controller, ensure sufficient cooling is provided in and around
Do not attempt to carry out any repair of the drive. In the case of suspected fault or malfunction, contact your local
supplier
Never connect the mains power supply to the Output terminals U, V, W
The drive must be installed within the limits specified in the technical data section
The motor must be used within the manufacturer’s guidelines
Failure to comply above Safety information and Precautions will result in potential risk of severe or minor personal
injury or even death and/or equipment damage