Inmes IM-300PL AL, Operator'S Manual

Page: 20 / 66

W A R N IN G
For the operator safety, the blades descent speed regulator leaves the industry closed. By doing that there is
no risk of injury if something touch the pneumatic foot pedal during the adjustments.
D A N G E R
Make sure the air supply is unplugged before every maintaining service.
Notice that the blade descent speed must be regulated according the profile and the finish wished. If the
speed was too high on a long profile, the blade may stop, as well the motor. The finish cut could be damage as well
your equipment.
6. 5 – Lubricant Spray (only for IM- 300PL AL)
For a high quality cut and long durability of the sawblades while cutting aluminum, the Double Miter Saw
IM-300PL AL is equipped with a lubricant spray system. Before starting the operation, please, fill the recipient 01
(fig. 25) with the oil lubricator. Proceed as follow:
1) Unpplug the hoses 02 (Fig. 25);
2) Open the cover 03 (Fig. 25);
3) Fill with the lubricant oil;
4) Cover the recipient ant plug again the hoses.
The quantity of the lubricant sprayed on the sawblade is adjusted at the factory. However, if any adjustment be
necessary, use the valve 01 shown in Fig 26:
Fig. 25 Fig. 26
Turn on the lubricant system as show in Fig. 23. As soon as you activate it, the liquid will start to spray through
the output 02 (fig. 26). (By the first time this may take a few seconds).
1) Turning the valve 01 (fig. 26) counter clockwise the volume of lubricant sprayed will increase.
2) Turning the valve 01 (fig. 26) clockwise the volume of lubricant sprayed will decrease.
INMES Industrial Ltda – Double Miter Saw IM-300PL 19