Inmes IM-300PL AL, Operator'S Manual

Page: 10 / 66

Fig. 05 Fig. 06

While working with the profile, never position it more than 5,00mm after the center of the table (Fig 07).
When necessary, make sure it cross at least 150,00mm as shown in fig. 08. This is necessary once the
clamping system needs to press both sides at the same time, ensuring that the profile be firmly tight.
Fig. 07 Fig. 08
The existing safety protection must not be removed. The infringement of these recommendations may
cause serious injury to the operator and damage to the machine;

Any operator must receive full training by an specialized operator before starting working with this
equipment;
D A N G E R

Never place your hands near the blades. If it is necessary to remove any scrap, turn the saw off unplug it
from the power source, and then remove the scrap.
D A N G E R
INMES Industrial Ltda – Double Miter Saw IM-300PL 9