Ingun 42600, User Manual

Page: 30 / 568

English
29
©
INGUN: Subject to technical changes without notice. E&OE.
locked.
5.5) Initial contacting
Before using the exhangeable kit for the first time, we recommend inspecting the position of the
test probes and pushrods on the electronic assembly. Here, it is particularly important to maintain
an adequate distance between the retention clamps and the components on the circuit board.
IMPORTANT R
ISK OF COMPONENT DAMAGE
!
If component positions vary significantly, pushrods may touch components or (partially) cover
them, thereby causing damage to the unit under test.

Ensure that there is enough clearance between the pushrods and the components!

If clearance is insufficient, use pushrods with a smaller diameter, or alternatively readjust/
remove the pushrods.
6) Operation
6.1) Exchangeable kit installation/removal
Before installing the exchangeable kit into the test fixture, ensure that both exchangeable parts
(probe plate unit and pressure frame unit) match both each other and the unit under test.
If the exchangeable kit is equipped with an internal interface, then the internal interface in the base
system must be fitted with the matching interface blocks in the correct position.
IMPORTANT R
ISK OF DAMAGE TO THE INTERNAL INTERFACE
!
Interface blocks that do not match one another can damage each other’s test probes.

Please check that the interface blocks in the internal interface of the exchangeable kit and
on the base system of the test fixture match one another.
Drive lock and transport lock
1) In unlocked position
2) In locked position
3) Screws for transport lock