60
Operating manual
ARCPULL 350
Translation of the original
instructions
8.4.4.2. Information Panel
Info machine
Soft gene V3.0
Hard gene V1.0
Pistolet 200-350
Soft pistolet V3.0
Hard pistolet V7.0
The information panel shows the machine’s software and hardward version numbers and, if connected, the type of
gun attached (200-350, 700).
9. ERROR MESSAGES, FAULTS, CAUSES AND SOLUTIONS
This equipment has a fault monitoring system. An error message will be shown on the display screen in the event of a fault.
Error message
Meaning
Causes
Solutions
DEFAUT THERMIQUE
The device’s thermal
protection.
Exceeding the duty cycle.
Wait until the message has
disappeared before resuming
welding.
DEFAUT SECTEUR
Mains voltage fault.
Mains voltage out of range
or missing a phase.
Have your electrical system
checked by an authorised per-
son. Reminder: the machine is
designed to operate on a single-
phase, 208-240 V AC, 50/60 Hz
network.
TOUCHE APPUYEE
Keypad fault.
A key on the keypad has
been pressed when the pro-
duct is switched on.
Have the keypad checked by a
qualified technician.
DEFAUT COM.
Gun communication fault. The communication sys-
tem between the gun and
the machine is not working
properly.
Reconnect the gun and turn
the welding machine off and on
again.
If the fault persists, have the
product checked by a qualified
technician.