48
Operating manual
ARCPULL 350
Translation of the original
instructions
Remove the knurled nut (no. 2 - Fig. 2)
from the gun’s drive shaft and screw in the
stud support.
Gently screw the gas shielding nozzle onto
the stud support, insert the stud support
until it can in no further and tighten the gas
shielding nozzle.
Assemble the rod-installation barrel with
the pad (pay attention to the positioning
of the holes) and fit the entire assembly to
the gun’s rods.
Loosen the gun’s locking knob (n°3 - Fig
2).
Adjust the barrel so that the tip of the
rivet-extraction rod protrudes slightly (0.5 -
2 mm) and tighten the gun’s locking knob.
0.5 - 2 mm
6.6. USING THE GRIP 700 CERAMIC FERRULE (P.N. 068339)
Note 1: Prepare the earth pins as explained in section 6.1.
Note 2: Prepare the stud support as explained in section 6.2.
Remove the knurled nut (no. 2 - Fig.
2) from the gun’s drive shaft and
screw in the stud support.
Gently screw the gas shielding
nozzle onto the stud support, insert
the stud support until it can in no
further and tighten the gas shielding
nozzle.