EN
47
Operating manual
ARCPULL 350
Translation of the original
instructions
Insert the pulling ring in the pulling ring support until
it can go in no further.
6.4. USING THE ARCPULL 350 RIVET CONSUMABLE KIT 1 (350 - 24 KN) (PN. 064584)
Note: Prepare the earth pins as explained in section 6.1.
Completely remove the adjusting screw
from the stud support and insert a rivet-ex-
traction rod until it can go in no further.
Remove the knurled nut (no. 2 - Fig. 2)
from the gun’s drive shaft and screw in the
stud support.
Gently screw the gas shielding nozzle onto
the stud support, insert the stud support
until it can in no further and tighten the gas
shielding nozzle.
Assemble the rod-installation barrel with
the pad (pay attention to the positioning
of the holes) and fit the entire assembly to
the gun’s rods.
Loosen the gun’s locking knob (n°3 - Fig
2).
Adjust the barrel so that the tip of the
rivet-extraction rod protrudes slightly (0.5 -
2 mm) and tighten the gun’s locking knob.
0.5 - 2 mm
6.5. USING THE ARCPULL RIVET BOX 2 350 - 50 KN (P.N. 073388)
Note: Prepare the earth pins as explained in section 6.1.
Insert the stainless steel rivet-extraction
rod into the stud support and adjust the
stud-retaining screw to ensure that it
extends between 13.5 - 15 mm from the
stud support.
13.5 - 15 mm