44
Operating manual
ARCPULL 350
Translation of the original
instructions
Causes
Solutions
Case 1: welding on flat
sheet metal
Case 2: welding on sheet
metal with metal obstacles
Case 3: welding on IPN
beams
6. SETTING UP CONSUMABLES AND ADJUSTING THE GUN
Installing and adjusting consumables on the gun must be done:
- with the gun connected to the power source
- with the device switched on
- when the gun’s initialisation phase is completed (trigger pull request)
Appui gachette
6.1. CHANGING AND ADJUSTING THE LENGTH OF EARTHING PINS (PN. 059627)
Note 1: It is necessary to replace the earth rods if they have excessive markings on their ends or if they have been
bent as a result of dropping the gun.
Note 2: Using the ARCPULL Rivet Boxes 1 and 2 (P.N. 064584 and 073388), as well as the Difficult-Access Box (P.N.
070813), requires using the short pins supplied with the ARCPULL 350.
Loosen the locking knob (no. 3 - Fig. 2) so that the
earthing rods (no. 4 - Fig. 2) are fully extended from
the gun.
Then tighten the locking knob.