GB
23
Fig. 13
Fig. 12
Heating element
Oven fan
l
l
the heating element is removed by unscrewing it
from the inside of the cooking chamber, having
removed preventively the shelterfan and lateral
side racks, by unscrewing it from the inside of the
cooking chamber. The electrical connections are
accessible from behind once the back panel has
been removed.
once the back has been removed, take off the fan
protection from inside the oven. Unscrew the left
nut to free the fan. Pull it out and then unscrew the
three screws holding the motor flange.
Having opened the door, pull it away from the oven
by completing the two movements illustrated by the
figure.
To complete these operations hold the door by the
sides at the bottom near the hinges.
To replace the door put the hinges back into their
appropriate positions. Before closing the door do
not forget to remove the two levers
“ ”
which were
used to hook the two hinges.
For cleaning the glass use only warmwater and
avoid using rough cloths or abrasive substances.
.
No special maintenance is required. It is enough to
be sure that the conductors, the controls and the
electric heating elements are in working condition.
For certain parts which can and may need to be
replaced, proceed in the following manner:
unscrew the protective cap
“ ”
which sticks out of
the inside of the oven to provide access to the
lamp. Immediately after the bulb has been
changed, remount the protection cover
“ ”
.
B
Cleaning of the glass
Do
not clean the glass when it is hot
Replacements
Oven lamp
A
A
l
The manufacturer cannot be held
responsible for possible damage to
persons or things if the instructions
given in this booklet are not followed
or, where insufficient, by the failure to
respect norms pertaining to the safety
of electric supply installations.
WARNING!
installation,
of the oven
according to the current and local
.
The
transformation and
non-routine maintenance
must be performed only by authorized
installers or by the electricity company
safety regulations
Control devices
Door seal
Safety devices
l
l
these can be reached by removing the control
panel and the oven shell.
take out the seal from its position and replace it
with a new one.
The oven is equipped the a safety thermostat inside
the control panel,
The oven features the grille to pervent contact with
moving parts in the oven cooking chamber.
if the oven cooking chamber
overheats, this device trips, cutting off the power
supply to the heating elements.
Summary of Contents for GIERRE BRIO INOX
Page 64: ...Cod LIB100 904 01001 19 ...