2 NVR Installation & Connection
2.1 HDD Installation
The system may not include hard disk depending on the kit you selected. The NVR works with most 3.5”
or 2.5” SATA HDD.
CAUTION: DO NOT
install or remove the hard disk drive while the device power is turned ON.
When power supply is disconnected, remove
the screws at both sides with screwdriver,
then remove the screws on the rear board,
and then remove top cover of NVR.
Connect data and power ports of hard drive
to motherboard.
Holding the hard drive and the NVR, gently
turn it over and line up the holes on the hard
drive with the holes on the NVR. Using a
screwdriver, screw the provided screws into
the holes. Two groups of screw mounting
holes are provided in the base frame of the
NVR, respectively for installation of 3.5” hard
drive and 2.5” hard drive. User should make
selection based on their hard drive size. After
complete HDD installation, assemble the
cover.
HDD Data & Power Ports
1
2
3
7