Document: RY-BCC8FDL 2A0
Page: 1
OWNER'S MANUAL
RY-BCC8FDL IP camera license plate
DSE srl - Digital Surveillance Equipment - WWW.DSE.EU
RY-BCC8FDL
PRODUCT DESCRIPTION
This IP camera is made to allow the resumption of license
plates of vehicles in slow or fast motion. It can operate in
any light condition thanks to the built-in IR illuminators.
Thanks to a High-Light Suppression system is not
influenced by the headlights of the vehicle is that dipped
beam.
Compatible with ONVIF protocol can be combined with any
management system or NVR that supports this standard.
RY-BCC8 is an IP camera "naked."
They are developed to work with an NVR or an external
recording software which is delegated all the video system
management.
If you choose a camera NAKED, care to also buy an NVR.
ASSEMBLY
The cameras are equipped with a mounting bracket for
wall built to allow the passage of cables within it. The
bracket is mounted generally at the output cables. The
fixing base has 4 holes for fixing to the wall with dowels.
The housing is waterproof and can be installed outdoors
without any protection.
The housing is air-conditioned and is equipped with a fan
which is activated at above 45 ° and a heater that is
activated at below -5 ° C.
POSITIONING
The positioning of the camera it is very important for a
good yield of the license plate reading.
The optimal recovery of the plate is carried out at a
maximum distance of 30 m. depending on the adjustment
of the lens.
The first thing to check is therefore that the distance as
the crow flies (not walkable on the ground) between the
camera and the point where you will find the means does
not exceed this distance otherwise the illumination of the
LEDs will not be effective.
The second thing to consider is to position the camera so
that the light of the headlights is not directly oriented
towards the camera, while maintaining an angle of
approximately 30 ° with respect to the illumination of the
headlights.
It ''s also wise to install the camera in position detected
above street level: from 3 to 8 meters you can have the
best results.
Satisfied 3 above, orienting the camera needs to be done
so that the plate remains as long as possible in the field of
vision of the camera.
The optimal reading is obtained by framing a single lane,
but you can take up to 3 lanes with a satisfactory reading.
The camera operates indifferently framing the rear or
front plates.
CONNECTIONS
The connections on the output cable from the camera are
the following:
pin DC12V - must connect a 12VDC power supply
stabilized by at least 2,000 mA, such as RE-AL5 model
(not included).
These cameras, also support the power supply from POE
network switch. If you are using the power POE, the
12VDC plug must not be connected.
Network RJ45 socket - Network port to connect to a
switch
NETWORKING
Connect the camera's network port to a port of the
network switch with a right network cable.
If you use a switch with ports POE the camera will draw
power from the network cable. Otherwise you will need to
connect a 12VDC power supply to the power input.
Check that the LEDs of the door of the network switch
start blinking, which confirms that the network has
established dialogue.
DOWNLOAD SOFTWARE AND MANUAL
You can download the manual and the software from our
website in the appropriate sections. Search IP CAMERAS
SERIES and RY.
IP ADDRESS ASSIGNMENT
The camera has the IP address 192.168.1.11 Factory
The factory logon credentials:
USER: admin
