EMCY Objekte
Folgende Fehlercodes gemäß DSP-401 bzw. DSP-301 werden unterstützt:
Wartung, Instandsetzung und Entsorgung
Da innerhalb des Moduls keine vom Anwender zu wartenden Bauteile enthalten
sind, darf das Gehäuse nicht geöffnet werden. Die Instandsetzung des Moduls
darf nur durch den Hersteller durchgeführt werden.
Die Entsorgung muss gemäß den nationalen Umweltvorschriften erfolgen.
Konformitätserklärung
Das CE-Zeichen wird angebracht auf Basis der EMV-Richtlinie EMV 89/336/EWG
sowie der Niederspannungsrichtlinie NS73/23/EWG.
DEUTSCH
CAN TASTATURMODUL
CPM 100
S
EITE
11
EMCY
Error
Zusatz
Beschreibung
Code
Reg
Code
0x6100
0x11
0x00
„Internal Software“
Überlauf einer Rx-Queue;
Frequenz der Rx PDOs zu groß.
Reset nur extern, über Eintrag in Idx 1003 00
0x6101
0x11
0x00
„Internal Software“
Überlauf einer Tx-Queue;
Gerät kommt nicht auf den Bus.
Reset nur extern, über Eintrag in Idx 1003 00
0x6200
0x81
0x00
„User Software“
Es wurde mehr als 1 Taste gleichzeitig gedrückt.
Auswertung des Tastenstatus ist nicht möglich.
Reset bei Lösen der Taste.
0x8100
0x11
0x00
„Monitoring“ (Guarding Error)
Für „guard time“ * „life time factor“
wird kein Guard-Objekt empfangen.
life time factor 0 entspricht 1
Reset bei node again
0x8200
0x11
0x00
„Monitoring“ (Synch Error)
Für „communication cycle“
wird kein Synch-Objekt empfangen;
(nur in OPERATIONAL)
Reset bei Synch-OBJ bzw. PREOP