IFM Electronic Ecomat 100 ecomatmobile SmartController CR2500, System Manual

Page: 35 / 300

ifm System Manual ecomat mobile SmartController (CR2500, CR2502) V05
Operating states and operating system Operating states
35
5 Operating states and operating system
Operating states ........................................................................................................................35
Status LED.................................................................................................................................36
Load the operating system ........................................................................................................37
Operating modes .......................................................................................................................37
5.1 Operating states
After power on the ecomat mobile controller can be in one of five possible operating states:
5.1.1 Reset
This state is passed through after every power on reset:
•
The operating system is initialised.
•
Various checks are carried out.
•
This temporary state is replaced by the Run or Stop state.
> The LED lights orange for a short time.
5.1.2 Run state
This state is reached in the following cases:
•
From the reset state (autostart)
•
From the stop state by the Run command
- only for the operating mode = Test (
→
chapter TEST mode,
→
page 38 )
5.1.3 Stop state
This state is reached in the following cases:
•
From the reset state if no program is loaded
•
From the Run state if:
- the stop command is sent via the interface
- AND: operating mode = Test (
→
chapter TEST mode,
→
page 38 )
5.1.4 Fatal error
The ecomat mobile controller goes to this state if a non tolerable error was found. This state can only
be left by a reset.
> The LED lights red.