IFM Electronic Ecomat 100 ecomatmobile SmartController CR2500, System Manual

Page: 13 / 300

ifm System Manual ecomat mobile SmartController (CR2500, CR2502) V05
Configurations PLC configuration
13
4 Configurations
Set up programming system......................................................................................................14
Function configuration of the inputs and outputs.......................................................................29
Hints to wiring diagrams ............................................................................................................34
The device configurations described in the corresponding installation instructions and in the annex
(
→
page 271 ) to this documentation are used for standard devices (stock items). They fulfil the
requested specifications of most applications.
Depending on the customer requirements for series use it is, however, also possible to use other
device configurations, e.g. with respect to the inputs/outputs and analogue channels.
WARNING
Property damage or bodily injury possible due to malfunctions!
The software functions described in this documentation only apply to the standard configurations. In
case of use of customer-specific devices:
► Note the special hardware versions and additional remarks (additional documentation) on use of
the software.
Installation of the files and libraries in the device:
Factory setting: the device contains only the boot loader.
► Load the operating system (
*.H86
)
► Create the project (*.PRO) in the PC: enter the target (
*.TRG
)
► (Additionally for targets before V05:) define the PLC configuration (
*.CFG
)
> CoDeSys
®
integrates the files belonging to the target into the project:
*.TRG, *.CFG, *.CHM, *.INI, *.LIB
► If required, add further libraries to the project (
*.LIB
).
Certain libraries automatically integrate further libraries into the project.
Some functions in
ifm libraries (
ifm_*.LIB
) e.g. are based on functions in CoDeSys
®
libraries
(
3S_*.LIB
).