IEI Technology POS-6614, User Manual

Page: 97 / 236

POS-6614 Motherboard
Figure 4-6: Securing the Heat sink to the PCB Board
Step 5:
Step 6:
Tighten the screws . Use a screwdriver to tighten the four screws. Tighten each
nut a few turns at a time and do not over-tighten the screws.
Connect the fan cable . Connect the cooling kit fan cable to the fan connector
on the POS-6614 motherboard. Carefully route the cable and avoid heat
generating chips and fan blades. Step 0:
4.4.3 DIMM Module Installation
4.4.3.1 Purchasing the Memory Module
When purchasing DIMM modules, the following considerations should be taken into
account:
Each DIMM module can support a memory chip with a maximum size of 1GB
It is recommended that memory modules of identical brand, size, chips, and
speed be used.
DIMMs must use the same density memory chips.
Both DIMMs must use the same DRAM bus width.
Both DIMMs must be either single-sided or dual-sided.
Page 97