Relay Retrigger Protection
Retrigger protection will not allow the relay to trigger again for 20 seconds
To setup retrigger protection:
1.
Switch dip switches 5 and 7 on
2.
Switch dip switch 8 on
3.
Select which relay by switching either dip switch 1 or 2 or both on
4.
Switch dip switch 8 off
5.
Switch the rest of the dip switches off
Relay Safe and Secure Mode
Safe and secure mode is a setting to cause the relays to either switch state or not when power is lost to
the receiver.
Secure Mode: The relays will not switch state
Safe Mode: The relays will switch state (E.g. If the relay is resting on normally open and power is lost it will
switch to normally closed.
To setup safe and secure mode:
1.
Switch dip switch 6 on
2.
Switch dip switch 8 on
3.
Select which relay by switching either dip switch 1 or 2 or both on
4.
Switch dip switch 8 off
5.
Switch the rest of the dip switches off
Stand-alone Mode
Stand-alone mode is when the receiver is not connected to the IDS805 bus.
To change any of the receiver settings follow the procedure as described in the previous section.
Learning remotes
To learn remote transmitters to a stand-alone receiver:
1.
Switch dip switch 3 on
3
2.
Press a button from each remote transmitter
3.
Switch dip switch 3 off
4.
Deleting remotes
To delete a remote transmitter from a stand-alone receiver:
1.
Switch dip switch 1 on
1
2.
Press a button from the remote transmitter to be deleted
3.
Switch dip switch 1 off