- 12 -
● Confirm that the leakage protection switch is installed. The leakage protection switch must be installed,
otherwise it may cause electric shock.
● Connect the cable correctly. If the cable is connected incorrectly, electrical parts may be damaged.
● DO NOT operate the unit near flammable materials (such as paint, paint, gasoline, chemical reagents, etc.) to
prevent fire or explosion. If cause fire, should turn off the main power immediately and extinguish the fire with fire
extinguishers.
● Regularly check and make sure that the erecting platform is secure and intact.
If the erecting platform is damaged and not strong, the unit may fall and cause casualties.
● When cleaning the unit, should cut off the manual power switch. If not, it may cause damage to the unit or
personal injury.
● Do not touch the refrigerant exhaust parts by hand to prevent burns.
● Please use the corresponding fuse. It can not be replaced by copper wire or iron wire. Otherwise, the unit will
be seriously damaged or fire.
● Do not spray flammable spray onto the unit, otherwise it may cause fire.
2.6 SELECTION OF INSTALLATION SITES
1. This outdoor unit is designed to be located outdoors with sufficient clearance for free entrance to the inlet and
discharge air openings. The location must also allow for adequate service access.
2. The installation position of the unit should avoid the boiler flue or other air environment that will corrode the
condensing coil and the metal parts of the unit.
3. If the unit is located in a location accessible to unauthorized personnel, isolation safety measures such as
guardrails should be taken. This will prevent sabotage and accidental damage.
4. The bearing surface of erecting platform of the unit should be flat, can withstand the weight of the unit, can
install the unit horizontally, and will not increase noise and vibration.
5. The operating noise and exhaust air of the unit should not affect neighbors.
6. There is no flammable gas leakage in the installation place of the unit.
7. Easy to carry out pipelines and electrical connections.
8. For occasions with special installation requirements, please consult the building contractor or architect or
other professional.
NOTE:
Installation in the following locations may cause machine malfunction (if it cannot be
avoided, please consult)
● In places where there is mineral oil such as cutting machine oil.
● In places where there is more salt in the air such as on the coast on the coast.
● In places where there are corrosive gases like sulfur gas in areas with hot spring.
● In places where the power supply voltage fluctuates severely.
● Outside the car or cabin.
● In places where is filled with oil such as in the kitchen .
● In places where there is a strong electromagnetic wave.
● In places where there are flammable gases or materials are present.
● In places where there is volatile acid gas or volatile alkaline gas.
● Other special environmental conditions.
Summary of Contents for ISW-10 SF1-DN1
Page 21: ... 21 XD 05BSPM ...
Page 56: ... 56 By sliding the button you can adjust the setting parameters Function buttons ...
Page 65: ......
