Idea ISW-10 SF1-DN1, Installation Manual

Page: 44 / 66

- 44 -
16 Compressor actual frequency
17 Low pressure sensor gauge
pressure value(R410 gas)
measured
（
bar
）
18 High pressure sensor gauge
pressure value(R410 gas)
measured
（
bar
）
19 DC Motor 1 speed
20 DC Motor 2 speed
21 Low pressure pressure conversion
temperature
22 High pressure pressure
conversion temperature
5.
“ ” Setting button
Clock settings:
Press the " " button to enter the clock setting state. First, the hour digit flashes, indicating that the hour value
of the current time can be adjusted through the " " and " " buttons. Each time you press the “ ” key, the
hour increases by one, and each time you press the “ ” key, the hour decreases by one. If you hold down the
" " or " " key for a long time, the hour will automatically increase or decrease. After setting the hour digit,
press the " " button again; at this time, the minute digit flashes, indicating that the current time's minute value
can be adjusted through the " " and " " buttons. After setting the minute value, press the " " key again to
end.
Timing setting:
Long press the " " button for 3 seconds to enter the timing setting:
Enter the timing selection. At this time, the "timing on 1" clock "hour" flashes, and the hours can be set with
" " and " "; press the" "button again to switch to the clock "minutes", and the" "and" "buttons
can be used to set the minutes.
；
Press the “ ” button again to switch to the “timing off 1 ”setting: the clock “hour” flashes, and the hours can be
set with the“ ”and“ ”keys; press the“ ”button again to switch to the clock “minutes”, with“ ” ,
" " Key can set points;
Other time periods are set by analogy;
Press " " to exit or confirm.
Press on the main interface, it will display the current number of set timing periods;
Cancel timing setting:
When the set power-on time and power-off time are the same, the timing setting of the current time period is
cancelled.