ICS ELECTRONICS 4863, Manual

Page: 22 / 167

1-17
1
TABLE 1-4 2363 CONFIGURATION PARAMETERS
Command Function Factory Setting
:BAUD Sets 2363's baud rate 9600
:PARity Sets 2363's serial parity NONE
:BITS Sets 2363's data bits 8
: :SBITs Sets 2363's stop bits 1
: :NETwork Sets RS-485 protocol OFF #
:ADDRess Sets 2363's address for network use 4 #
:INPut Sets number of Talk bytes 6 #
:POLarity Sets Input polarity 1 #
:HANDshake Enables Input Handshaking ON #
:TALK Selects Input Format HEX #
:TRANslation Sets input conversion table for BCD
HEX characters
see note #
:OUTput Sets number of Listen bytes 0 #
:POLarity Sets Output polarity 1 #
:LISTen Sets Output Format HEX #
:HANDshake Enables Output Handshaking OFF #
:CLEar Sets Clear pulse active level 0 #
:EDR Sets EDR input active level 0 #
:INHibit Sets Inhibit output active level 1 #
:REMote Sets Remote output active level 0 #
:RESet Sets Reset pulse output active level 0 #
:STRobe Sets Data Strobe pulse active level 0 #
:TRIGger Sets Trigger pulse active level 0 #
:ASTATus Sets Status A input active level 1 #
:BSTATus Sets Status B input active level 0 #
:LOCK Blocks # items from changes Off
:IDN Sets user's IDN message ICS IDN msg #
:QUES Reg Enables digital signal changes 0 *
:PTRANSISTION Enables positive going inputs All 1s *
:NTRANSISTION Enables negative going inputs All 0s *
*ESE Enables events to generate an SRQ 0
*SRE Enables Summary bits to generate 0
an SRQ
* Indicates parameters that cannot be saved in the unit's nonvolatile memory.
# Indicates parameters that may be blocked by the LOCK command.
Std Conversion Table is 0123456789ABCDEF