ii
INTRODUCTION
FEATURES
•The IP1000C enables you to communicate through IP networks by using the IP1000C as a controller for the
Icom Wireless LAN transceivers IP100H and IP110H (described as “WLAN transceivers” in this manual.)
- A wireless access point is required.
IP100FS
(Remote Communicator)
IP1000C
Wireless
access
point
Connection example
IP
Network
IP100H
•
A total of up to 100 WLAN transceivers and IP100FSs
remote
communicator
can be registered and used in
the IP1000C system. (Depending on the IP1000C versions, only 20 terminals can be registered.)
- The IP100FS enables you to remotely communicate with WLAN transceivers connected to your IP1000C
from a PC through an IP network.
•
The IP1000C has two methods of communications (Simplex and Full-Duplex.)
- The Simplex is for communications where receptions and transmissions are done alternately one by one,
and the Full-Duplex is for simultaneous receptions and transmissions as a telephone call.
•
The call types are All Call, Group Call, Talkgroup Call, Individual Call, and Telephone Call.
- The Talkgroup Call is the terminal selects the group that it belongs to.
•
In the All Call, Group Call and Talkgroup Call, you can assign the simplex or full-duplex mode to the each
calls.
•The Area Calls can be operated by limiting to a certain area.
•
If you connect with Icom’s VE-PG3 (ver. 1.13 or later), you will be able to communicate with certain types of
Icom transceivers.
Also If you connect in bridge port with Icom’s VE-PG3 (ver. 1.03 or later), you will be able to communicate
using the VoIP router, which enables you make extension phone calls and outline phone calls.
Only the VE-PG3’s bridge ports that are set in the converter mode are connectable.
•A total of up to 50 ID list and 10 messages can be programmed for each setting group.
•
Status settings can be programmed to send the status information (Example: Away from the desk) from the
WLAN transceiver.
- Up to 10 statuses can be programmed.
•
The settings configured with the IP1000C is automatically set when the WLAN transceiver is turned ON.
•
Automatic firmware updates for the WLAN transceivers can be done using the IP1000C.
•The LAN ports automatically select from 10BASE-T, 100BASE-TX or 1000BASE-T, and detect the port
polarity type between MDI (straight) and MDI-X (crossover), depending on the connected devices.
•The [LAN] port is equipped with 4-port switching HUB.
•Supports SNMP as the network management.
•
Automatic Restore using a USB flash drive.
•You can communicate with IP100Hs connected to the additional IP1000Cs on the network by using the
[Additional Controller Link] function.
- Use a VPN router such as Icom’s SR-VPN1 between sites, if necessary.
L
This document is described based on the IP1000C firmware version 2.48.