Icom IP1000C, Instruction Manual, Page: 193 / 246

4
ABOUT THE SETTING SCREEN
4-140
10. [Destination Settings] Menu [Destination Settings]–[Destination Settings]
■
Destination Settings Call Type: Group
7
WLAN Transceivers ��� Click to select the WLAN transceivers or IP100FS which belong to the
group.
L
Only the WLAN transceivers or IP100FSs that are registered in the
[Transceiver Registration] screen are listed.
L
By clicking the [All] box, you can select or cancel all entries in the list.
8
Additional Controller �� Select the additional controller when configuring several controllers,
and the Group call calls between the different controllers.
L
By clicking the [All] box, you can select or cancel all entries in the list.
L
If [Sub] is selected on the [Controller Mode] item in the [RoIP Settings]
screen, select the Additional controller on this setting as shown below.
9
<Apply> �������� Click to apply the entries.
10
<Reset> �������� Click to restore the settings.
L
You cannot restore after clicking <Apply>.
TIP:
When configuring several controllers, set the same group setting between the controllers in the [Destination
Settings] screen (p. 4-137).
For example, in the Controller 1 setting, the “Additional Controller” of the Group 1 is set to the Controller 2,
you must set the “Additional Controller” of the Group 1 is set to the Controller 1 in the Controller 2 setting.
L
Even if you configure three or more controllers using one Master and two or more Subs, follow the manner above.
1
2
3
4
5
6
7
8
9
10
(These are examples when the “Call Type” item is set to “Group.”)