![background image](http://html.mh-extra.com/html/icom/ic-f620/ic-f620_programming-software-manual_612653068.webp)
CS-F620TR Programming Software Manual
(rev 1.0) -
Trunking Features Programming Screen
65
Group
Row
Description
Default
Suggested
Settings
PassPort
Features
Reacquire
Time
Enter from 0 to 250. If a PassPort radio
goes into search (roam) mode and it
attempts to go back to the same site it left, it
will not attempt to register to the site
(because it probably does not need to)
unless this period of time has elapsed.
90.000
90.000
PassPort
Features
Selective Call
Wait Time
Enter from 10 to 30. This is the amount of
time the radio will wait for a successful
selective call to be setup by the system after
the radio initiates a selective call.
20.000
30
Other Time
Loss of
Carrier Roam
Start
Enter from 2 to 250. This is the amount of
time between when radio has lost low speed
data from the PassPort system that it is
currently registered to and when it will go
into search (roam) mode.
30.000
20
Other Time
Select System
Roam Delay
Enter from 2 to 250. After a new system is
selected, this is the amount of time the radio
will wait until initiating search (roam)
mode.
11.000
7
Other Time
Roaming
Wait
Select from 2 to 65.535. If a radio is in
search (roam) mode, this is the amount of
time the radio will wait on each frequency
for PassPort data activity before moving on
to the next frequency in its neighbor lists or
seed list.
5.500
This setting
should be set
to about 2.5
times the idle
message
interval of the
PassPort
system. For
example, if
the system is
setup to send
out an idle
message
every 2
seconds, then
the suggested
setting here
would be “5”.
When done editing in this programming screen you can proceed to other programming
screens, save your programming parameters to a file or proceed to writing the
information to the radio (assuming that editing has been finished for all other required
programming screens also).