11
Bluetooth
®
OPERATION
11-4
NOTE: For the Portable Ten-key and the Simple
key types and Mobile LCD types
•
To turn ON the Bluetooth
®
function: See page 11-3
•
To pair with a headset:
See page 11-6
•
To pair with a data device:
See page 11-9
Portable:
Step 1: Entering the Bluetooth
®
Set mode
(Transceiver)
1� Turn OFF the transceiver�
2� Set [Selector] to any channel other than Channel
16�
3� While holding down [F1], turn ON the transceiver�
Continue holding down [F1] for about 3 seconds�
•
2 beeps sound�
•
The transceiver enters the Bluetooth
®
Set mode�
Step 2: Entering the Pairing mode
(Bluetooth
®
device)
L
See the Bluetooth
®
device’s instruction manual for
details�
Step 3: Turning ON the Bluetooth
®
function
(Transceiver)
After the headset has entered the Pairing mode, push
[F2] to turn ON the Bluetooth
®
function�
•
The transceiver automatically enters the Pairing mode, and
begins searching for a Bluetooth
®
headset�
•
While searching, the status indicator quickly blinks blue�
L
If the status indicator does not blink after pushing [F2],
the transceiver has not entered the Bluetooth
®
Set mode�
In that case, do step 1 again�
Step 4: Pairing with a headset
(Transceiver)
When a headset is found, the transceiver pairs with it�
•
After the transceiver and the headset pairing has
succeeded, the Status indicator slowly blinks blue 3 times�
In that case, the connection to the headset has also
succeeded�
L
Thetransceiversearchesforaheadsetfirst.After
searching for a headset, the transceiver will start
searching for a data device� To skip searching for a data
device, push [PTT] on the headset�
L
If the Bluetooth
®
connection fails, the Status indicator
slowly blinks red 3 times� To search for a headset again,
push [F3] to turn OFF the Bluetooth
®
function, then push
[F2] to turn it ON again�
This section describes how to turn ON the Bluetooth
®
function and start pairing using the Portable Non-
display types or Mobile Segment types�
[VOL]
[F1]
[F2]
[F3]
Step 5: Pairing with a data device
(Transceiver)
1� When a data device is found, the transceiver pairs
with it�
•
After the transceiver and the data device pairing has
succeeded, the Status indicator slowly blinks blue 3
times� In that case, connection to the data device has
also succeeded�
L
If the Bluetooth
®
connection fails, the Status indicator
slowly blinks red 3 times� To search for a data device
again, push [F3] to turn OFF the Bluetooth
®
function,
then push [F2] to turn it ON again� The transceiver
automatically tries to connect�
2� Turn OFF the transceiver, then turn it ON again to
exit the Bluetooth
®
Set mode�
D
For the Portable Non-display types and Mobile Segment types
TIP:
To turn OFF the Bluetooth
®
function, push [F3]
in the Bluetooth
®
Set mode�
Turning ON the Bluetooth
®
function
