Maint
06-0110
6.5.2
Level of ultrasonic sensor
(1) Specify the parameters and click [Run]. Do not put sheets in between ultrasonic sensors at this time.
•
Ultrasonic sensor number
: 1
(Default)
•
Ultrasonic sensor operation mode
: 02
(Default)
•
Motor
: Main
(Default)
•
Motor speed
: Speed1 (High Speed)
(Default)
•
Transmit waves
: ON
(Default)
•
Motor operation
: OFF
(Default)
•
Scanner light source (Front)
: Light on
(Default) *1
•
Scanner light source (Back)
: Light off
(Default)
*1 :If "Light on" is selected, the scanner lamp flashes with the motor operation.
(2) The level of the ultrasonic sensor is displayed and refreshed every couple of seconds.
If you want to stop changing the level, click [Pause]. Then the [Pause] button changes to the the [Run] button.
If you want to exit the window, click [Finish].
Perform the scanner-side work while the level display is paused. When the level display is executed, the status
is continuously updated.
The figure below shows the window when the [Pause] button is pressed and the level is constant.
