IBM TotalStorage, Installation Manual

Page: 48 / 91

15. IMPORTANT : This step must be the last step you perform on the master
console before handing over the machine; it sets up the master console to
present a Windows license agreement screen at the next power on and then
shuts down the master console.
a. Select Start –> Run
b. Enter c:\sysprep\sysprep.exe
c. Click OK .
Note: It is important that you do this step; otherwise, the customer will not
be presented with the choice to accept or decline Windows registration
conditions.
Related topics:
v
IBM TotalStorage SAN Volume Controller: Planning Guide
Installing the support rails and the SAN Volume Controller into a rack
This topic and its subtopics provides information about installing the support rails
for the SAN Volume Controller and installing the SAN Volume Controller into a
rack.
Installing the support rails for the SAN Volume Controller
The following task describes how to install the support rails for the SAN Volume
Controller.
Steps:
Perform the following steps to install the support rails for the SAN Volume
Controller:
1. Refer to the customer’s hardware location table to find out where in the rack
the SAN Volume Controller is to be installed.
2. Refer to the EIA markings on the rack and decide where you are going to
install the support rails.
3. Check the labels on the support rails; each rail has a label that indicates which
is the front end of the rail and whether the rail is for the left or right side of
the rack. Perform this procedure for both rails.
4. Put your finger against the side of the latch lever
1
, and put your thumb
against the front of the latch lock
2
(see Figure 27 on page 27).
26
Installation Guide