IBM TotalStorage, Installation Manual

Page: 49 / 91

5. Gently push the latch lock
2
(Figure 28 ) away from the rail as you move
the latch lever
1
towards the far end of the rail. The latch-lock carrier
assembly slides against the spring tension.
6.
Continue to slide the latch-lock carrier for approximately 13 mm (0.5 in). The
latch lever engages a hole in the back bracket assembly, and holds the
latch-lock carrier in the retracted position.
7. Push the back rail bracket
1
(Figure 29 on page 28) toward the front of the
rail until it stops. The rail is now at its shortest adjustment.
1
2
Figure 27. Retracting the latch lock carrier
1
2
1
2
Front
Figure 28. Opening the front latch-lock carrier assembly
Chapter 4. Installing the uninterruptible power supply, the master console, and the SAN Volume Controller
27