Statement 2:
CAUTION:
When replacing the lithium battery, use only IBM Part Number 33F8354 or an
equivalent type battery recommended by the manufacturer. If your system has
a module containing a lithium battery, replace it only with the same module
type made by the same manufacturer. The battery contains lithium and can
explode if not properly used, handled, or disposed of.
Do not:
v
Throw or immerse into water
v
Heat to more than 100°C (212°F)
v
Repair or disassemble
Dispose of the battery as required by local ordinances or regulations.
To install the battery, complete the following steps.
1. Follow any special handling and installation instructions that come with the
battery.
2. Tilt the battery so that you can insert it into the socket on the side opposite the
battery clip.
3. Press the battery down into the socket until it clicks into place. Make sure that
the battery clip holds the battery securely.
4. If you removed the PCIe riser-card assembly, install it (see “Installing a PCIe
riser-card assembly in the system-board tray” on page 116).
5. Install the expansion enclosure, if you removed one (see “Installing an
expansion enclosure on a system-board tray” on page 74); otherwise, install the
system-board tray cover (see “Installing the system-board tray cover” on page
122).
6. Install the system-board tray in the chassis (see “Installing the system-board
tray in a 2U chassis” on page 76 or “Installing the system-board tray in a 3U
chassis” on page 78).
7. Turn on the system-board tray and run the BIOS configuration utility program.
Chapter 4. Removing and replacing server components
87
