IBM SAN Volume Controller 2145-CG8, Hardware Installation Manual

Page: 56 / 110

Note: The maximum distance between the front and the rear EIA rails of the
rack is 810 mm (31.9 in.).
Each slide rail is marked with either an R (right) or an L (left). Select one of the
slide rails and pull the rear bracket all the way back. If a thumbscrew is
installed in the slide rail, remove it.
3. Install the rear end of the slide rails, as shown in Figure 22.
From the front of the rack, line up the two pins on the rear of the slide rail in
the selected U on the rear of the rack. Push the rails so that the pins go into the
holes and slide the rails into the rack to lock the rear of the slide rails into the
rack.
4.
Prepare the front end of the slide rails, as shown in Figure 23 on page 29.
Figure 21. Opening the rear slide-rail hooks
Rear of rack
Figure 22. Installing the rear end of the slide rails
28
SAN Volume Controller: Model 2145-CG8 Hardware Installation Guide