IBM SAN Volume Controller 2145-CG8, Hardware Installation Manual

Page: 62 / 110

Installing the SAN Volume Controller 2145-CG8 in a rack
After installing the support rails, you can install the SAN Volume Controller
2145-CG8 node in the rack.
Before you begin
CAUTION:
To avoid any hazard from the rack tipping forward when devices are installed,
observe all safety precautions for the rack into which you are installing the
device.
About this task
To install the SAN Volume Controller 2145-CG8 node in the rack, perform the
following steps:
Procedure
1. Place the SAN Volume Controller 2145-CG8 in the rails on the rack.
a. Pull the slide rails forward until they click twice into place.
See
1
in Figure 30 on page 35.
b. Lift the node and carefully tilt it into position over the slide rails. Line up
the rear nail heads
2
on the node line up with the rear slots
3
on the
slide rails.
c.
Slide the node down until the rear nail heads slip into the two rear slots.
Figure 29. Connecting and routing the cables
34
SAN Volume Controller: Model 2145-CG8 Hardware Installation Guide