IBM RS/6000 H50, Installation And Service Manual

Page: 116 / 327

Table 3-5 (Page 4 of 10). Firmware Checkpoints.
Checkpoint Description Action/
Possible Failing FRU
E15C Probe primary 64 bit PCI bus See the note on 3-30.
E15D Create host PCI controller node See the note on 3-30.
E15E Create MPIC node See the note on 3-30.
E15F Adapter VPD probe See the note on 3-30.
E160 CPU node VPD creation See the note on 3-30.
E161 Root node VPD creation See the note on 3-30.
E162 SP node VPD creation See the note on 3-30.
E164 Create PCI graphics node (P9) See the note on 3-30.
E168 Create PCI graphics node (S3) See the note on 3-30.
E16C GTX100P Subsystem Open request. See the note on 3-30.
E16D GTX100P Planar not detected or
failed diagnostics. See the note on 3-30.
E16E GTX100P Subsystem Open suc-
cessful. See the note on 3-30.
E16F GTX100P Close Subsystem. See the note on 3-30.
E170 Start of PCI Bus Probe See the note on 3-30.
E171 Executing PCI-Delay function See the note on 3-30.
E174 Establish host connection Refer to “E1xx Code Boot
Problems” on page 3-46 for general
considerations.
E175 BootP request Refer to “E1xx Code Boot
Problems” on page 3-46 for general
considerations.
1. Turn off then on, and retry the
boot operation.
2. Verify the network connection
(network could be down).
3. Have network administrator
verify the server configuration
for this client.
E176 TFTP file transfer See the note on 3-30.
E177 Transfer failure due to TFTP error
condition See the note on 3-30.
E178 Create PCI token ring node See the note on 3-30.
E180 SP Command setup See the note on 3-30.
E183 SP Post See the note on 3-30.
E190 Create ISA node See the note on 3-30.
E193 Initialize Super I/O. See the note on 3-30.
3-36
RS/6000 Enterprise Server Model H50 Installation and Service Guide