IBM 865951Y - Netfinity 5000 - 51Y, Hardware Maintenance Manual

Page: 173 / 220

SCSI error codes
Error Code FRU/Action
All SCSI Errors
One or more of the following
might be causing the
problem:
Ÿ
A failing SCSI device
(adapter, drive,
controller)
Ÿ
An improper SCSI
configuration or SCSI
termination jumper
setting
Ÿ
Duplicate SCSI IDs in
the same SCSI chain
Ÿ
A missing or improperly
installed SCSI
terminator
Ÿ
A defective SCSI
terminator
Ÿ
An improperly installed
cable
Ÿ
A defective cable
1. External SCSI
devices must be
powered-on before
you power-on the
server.
2. The cables for all
external SCSI devices
are connected
correctly.
3. If you have attached
an external SCSI
device to the server,
make sure the external
SCSI termination is set
to automatic.
4. The last device in each
SCSI chain is
terminated correctly.
5. The SCSI devices are
configured correctly.
Undetermined problems
You are here because the diagnostic tests did not identify
the failure, the Devices List is incorrect, or the system is
inoperative.
Notes
1. If you suspect a software mismatch is causing
failures (solid or intermittent), be sure to see
“Resolving resource conflicts” on page 50.
2. A corrupt CMOS can cause undetermined
problems.
Check the LEDs on all the power supplies. If the LEDs
indicate the power supplies are working correctly, return
here and do the following:
1. Power-off the computer.
2. Be sure the system is cabled correctly.
3. Remove or disconnect the following (one at a time)
until you find the failure (power-on the computer and
reconfigure each time).
Ÿ
Any external devices
Ÿ
Surge suppressor device (on the computer)
Ÿ
Modem, printer, mouse, or non-IBM devices
Ÿ
Each adapter
Ÿ
Drives
Ÿ
Memory-Module Kits (Minimum requirement = 1
bank of 64 MB DIMMs)
Ÿ
Secondary microprocessor VRM, if installed
Netfinity 5000 - Type 8659
165