3-21
Load Clinical Software and Configure System
032-0330-EN Rev K
f.
If DEXIS is installed, select
next to Practice URL, then select the Practice URL from
the dialog. Enter the Username and Password for the server, then select
Test
to ensure
the connection is established. Click
OK
on the pop-up.
g.
Click
Save & Restart
. A message is displayed “Restarting Integration Services. Please
wait (up to 10 minutes).”
NOTE:
•
If the PACS Storage Service was loaded, and has not been set up, you will get a PACS
Station error message when closing this window. See
Configure SmartScan STUDIO
PACS Modules (Optional) (page
3-26)
for additional setup instructions.
•
If the Legacy Practice Management Interface was loaded, refer to
Configure Legacy
Practice Management Interface (Optional) (page
3-30)
for additional setup instructions.
Install SmartScan STUDIO Client Components
SmartScan STUDIO Manager should be loaded on any workstation where the site will be entering
patient exam data or viewing patient images. For sites that use a PACS, load the required SmartScan
STUDIO PACS software on each workstation. For sites that use a supported PM system, load the
Legacy Practice Management Viewer Launcher on all workstations that use it.
1. At clinical workstation, insert media in drive.
2.
On AutoPlay pop-up, select
Run SssInstallerExecutive.exe
. If AutoPlay pop-up does not
display, navigate to the media drive, right-click and select
Open AutoPlay
.
3.
On the SmartScan STUDIO Installer Executive:
a.
Select programs to be installed.
Summary of Contents for FLX
