i-CAT FLX, Installation Manual, Page: 20 / 106

1-12
i-CAT FLX Installation Manual
032-0330-EN Rev K
1. Determine proper bracket set configuration to use based on outlet
receptacle and wall plug that will be used. See figure and use
configuration A or B.
2. Plug scanner line cord into wall receptacle.
3. For configuration A, loosen hardware holding bracket set together
so that brackets can slide freely for positioning.
For configuration B, remove hardware holding bracket set together.
Flip the position of the bracket that will rest on the face of the plug,
then loosely secure brackets together with hardware.
4. Position bracket set in intended location over line cord and mark the
relative position of the brackets to each other with a pencil.
5. In a work area, align the mark on the brackets, and tighten
hardware.
6. Position assembled bracket set over line cord, and mark the wall
with the location of the two holes needed to mount the bracket set.
7. Put bracket set aside and drill mounting holes.
NOTE: Use wall anchors/screws or appropriate mounting hardware to mount the bracket set to the
wall. The type and length of mounting hardware used must be suitable for the wall to which the
bracket set is fixed. The installer is responsible for obtaining the proper mounting hardware.
8. Install appropriate mounting hardware to mount the bracket set to the wall, trapping the line cord
in place.
A
B
3/16
3/16