Hypertherm HyPrecision 15, Operator'S Manual

Page: 47 / 194

HyPrecision15/30/50 Operator Manual 808240 47
4 – Operation
O
p
eration
Operator interface
The operator interface is a programmable controller for the pump and the intensifier. A series of screens shows
equipment status and permits the operator to operate the pump and intensifier.

The operator interface described in this section is the standard controller for this pump. Some original equipment
manufacturers (OEMs) or system integrators might change the controller. In these cases, refer to the documentation
provided by the OEM or system integrator for operation instructions.
Operation panel
The operation panel turns the control circuit inside the pump on and off and switches between local and remote pump
operation.
The CONTROLS ON button turns on the controls. The controls must be on to operate the pump.
The EMERGENCY STOP pushbutton turns off the control circuit inside the pump, which turns off the pump, primary
motor, and intensifier, and opens the bleed-down valve to discharge high-pressure water from the system.
When the LOCAL/REMOTE key switch is in the LOCAL position, the pump operates normally. When the key switch is in
the REMOTE position, the remote source controls the pump and the REMOTE ACTIVE indicator light is on.
Primary breaker disconnect lever
1
2
3
5
4
6
1 Hour meter
2 F1 and F2
3 Numeric keypad
4 Date and time
5 Enter
6 Direction arrows
4
3
2
1
1 CONTROLS ON button
2 LOCAL/REMOTE key switch
3 EMERGENCY STOP pushbutton
4 REMOTE ACTIVE indicator light