Hypertherm HyPrecision 15, Operator'S Manual

Page: 22 / 194

SC-22 Safety and compliance
Symbols and marks
Symbols and
marks
Symbols and marks found on the data plate and the pump
Some symbols or marks in this table could be relevant to other products.
DANGER
To reduce the risk of serious injuries or death, wear approved protection and follow safety
recommendations when working with electricity.
WARNING
Do not touch a hot surface.
Caution
Refer to the instruction manual. Read and understand all of the safety guidelines in this manual.
Correct direction of motor rotation (motor rotation arrow)
S/N
Serial number
V
Volts
Φ Number of phases in a power system
Hz
Frequency (hertz)
FLA
Full-load current (amperage)
SCCR
Short-circuit current rating
IP Ingress protection rating
Imax
Primary motor maximum current draw (amperes)
kW
Primary motor power output (kilowatts)
l/min Maximum outlet flow rate (liters/minute)
MPa
Maximum outlet water pressure (megapascals)
DWG
System schematic drawing number
The Conformité Européene (CE) mark shows that a product complies with standards relevant
to the product to which the mark is affixed.
The CE mark signifies the manufacturer’s declaration of conformity to applicable European
directives and standards. Only those versions of products with a CE mark found on or near the
data plate have been tested for compliance with the European Low Voltage Directive and the
European Electromagnetic Compatibility (EMC) Directive.